Garmin G1000 Mooney M20TN - Manual (Page 64)

Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 190-00647-02 Rev. A 50
FLIGHT INSTRUMENTS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
The Arc HSI is a 140˚ expanded section of the compass rose. The Arc HSI contains a Course Pointer,
combined To/From Indicator and a sliding deviation indicator, and a deviation scale. Upon station passage, the
To/From Indicator flips and points to the tail of the aircraft, just like a conventional To/From flag. Depending
on the navigation source, the CDI on the Arc HSI can appear in two different ways, an arrowhead (GPS, VOR,
OBS) or a diamond (LOC).
Lateral
Deviation
Scale
Course
Deviation
and To/From
Indicator
Figure 2-11 Arc HSI
Course Pointer
Navigation
Source
Flight Phase
Annunciation
Track Indicator
The selected heading is shown to the upper left of the HSI for 3 seconds after being adjusted. The light blue
heading bug on the compass rose corresponds to the selected heading. While the HSI is displayed as an arc, if
the heading bug is adjusted off the shown portion of the compass rose, the digital reading is displayed.
Adjusting the selected heading:
Turn the HDG Knob to set the selected heading.
Press the HDG Knob to synchronize the bug to the current heading.
The Selected Course is shown to the upper right of the HSI for 3 seconds after being adjusted. While the
HSI is displayed as an arc, the Selected Course is displayed whenever the Course Pointer is not within the 140˚
currently shown.
Adjusting the Selected Course:
Turn the CRS Knob to set the Selected Course.
Press the CRS Knob to re-center the CDI and return the course pointer to the bearing of the active waypoint or
navigation station.
Selected
Heading
Selected
Course
Figure 2-12 Heading and Course Indications (Magnetic)
Current Heading Heading Bug