Garmin GPSMAP 396 - Manual (Page 167)

GPSMAP 396 Owner’s Manual 59
A
PPendIX
> I
nstAllAtIon
I
nforMAtIon
Connecting Your GPSMAP 396 to a Computer
Your GPSMAP 396 can be connected to your computer using the
included USB-PC Interface Cable to connect to a USB data port
or the optional PC Interface Cable to connect to a DB-9 serial
communications port.
notE: Fully install the supplied MapSource program, Trip &
Waypoint Manager, on your computer before connecting the
USB cable to the computer.
To connect your GPS to your computer:
1. Connect the small end of your cable to the lower connector on
the back of the GPSMAP 396, shown in the illustration to the
left.
2. When using the supplied USB Data Cable, connect the larger
end of the cable to an available USB data port (see illustration
on the left).
When using a PC Interface Cable, connect the larger end of
the cable to a serial communications port on your computer
(see illustration on the bottom left).
USB Data Port on your PC
Serial Communications Port
USB
connector
under
weather cap
Information about USB Drivers
The USB drivers should have been automatically installed when you
installed the MapSource program that came with your GPSMAP
396. When you initially connect the GPSMAP 396 to a USB port,
your computer prompts you to locate the destination of the drivers
for the device. You only need to install the drivers once. After the
drivers are installed, your computer always detects your GPSMAP
396 when it is connected. USB drivers are updated periodically. You
can find these updates at www.garmin.com .