Audiopipe TS-VR15 - Manual (Page 5)

Use 3⁄4” or thicker MDF (medium density fiberboard) and seal the joints with silicone.
All the cubic ft measurements in this manual include the displacement of the woofer
and port. All ports have been calculated using rectangular ports it would be impractical
to use round ports for these designs. Do not install ports opening against a solid surface,
such as an internal brace, back panel or seat of your vehicle. The port opening must
remain unobstructed.
Primary advantages: Small, good low frequency extension and control, simple to build.
This type of enclosures is a classic design and the easiest to build among most installers.
These enclosure recommendations have been calculated with the airspace inside and include
the displacement of the woofer. All sealed enclosure designs should be filled to 50% with
loose poly-fil stuffing. The use of poly-fil will slightly decrease efficiency but will deepen
and extend the low frequency output.
TS-V6
TS-VR8
TS-VR10
TS-VR12
TS-VR15
Subwoofer
0.25 FT
3
0.5 FT
3
1.0 FT
3
1.75 FT
3
2.25 FT
3
?” x ?” x ?”
10” x 10” x 11”
12” x 12” x 13”
14” x 14” x 16”
16” x 16” x 18”
External Dimensions
(Width x Height x Depth)
Volume
(net int.)
Recommended Sealed Enclosure
D
H
W
-3-