Blue Ox BRK2010 - Manual (Page 7)

In Towed Vehicle:
1. Open driver side door of towed vehicle, and push
driver seat back as far as possible.
2. Place BRK 2010 Patriot® on the fl oor.
3. Open “Claw” and place it on the brake pedal. (Fig. 1)
Note: The easiest way is to place the bottom of the claw
under the pedal fi rst, then slide the top of the claw over
the top of the pedal.
4.The feet can be attached for proper height position. The
rubber boots may be removed to expose the grippers on
the feet.
Note: Do not store or transport with the feet attached
to the unit.
5. Slide the driver’s seat forward to touch push pads.
Adjust the push-pad up or down for proper height
position in relation to the seat.
Note: Seat must be as far forward as possible without
causing the brake lights to be activated. If the seat
can’t be moved forward far enough, an arm extension is
available. (see page 13)
Note: If using a breakaway, it must be connected before
turning on the unit.
6. Plug in power cord to cigarette lighter. Be sure there is
12 volt power. Indicator light will glow.
7. Turn on the power switch. (Fig. 2) Display will read
initializing.
8. When the display reads “Position Arm Then Press
Setup,” press the JOG switch to push slightly on the brake
pedal. (Fig. 3) The brake pedal should be depressed as
far as possible WITHOUT activating the brake lights.
9. Push the “SETUP” button.
The brake will stroke 3 (three) times then remain in the
ready position.
Note: If the brake extends fully and remains extended
without stroking three times, the seat is not far enough
forward. Turn the brake off then back on. Reposition the
seat as far forward as possible without causing the brake
lights to be activated then continue with Step 8.
Installation Setup
Th is section will explain how to install the
Patriot®.
Note: Prepare the car for towing. Attach the
tow bar.
Fig. 2 Turn on Power Switch
Fig. 3 Adjust the brake pedal with the Jog Switch
Fig. 4 Push the Setup Button
Page 8 of 16 405-0084 Rev. B 7/8/10
Fig. 1 Place claw on brake pedal