Blue Ox BRK2012 - Manual (Page 11)

405-0260 Page 11 of 15 3/28/12
Mounting the Break-Away Switch
1. With the pin facing the motor home, secure the
break-away switch onto the front of the towed
vehicle in a sturdy location. This should be a
convenient location which can be easily reached,
and if possible, on the driver’s side.
Note: The break-away switch must be mounted
directly on the towed vehicle and not to be installed
on the tow bar or bracket. The surface must be
strong enough to hold the break-away switch and
allow for the pin to be pulled out cleanly.
2. Make certain that the switch is securely attached,
and that the pin can be removed from the switch
without any interference. Plug the cable into the
break-away switch.
3. Install the Break-Away Switch using a bolt and lock
nut. Do not use a self tapping screw.
Connecting the Break-Away Switch
to the Patriot® Brake
There are two different ways to attach the break-away
device to the Patriot® Brake. Use the method which is
most convenient for you.
Method 1: Through the frewall
1. Look for a preexisting hole in the frewall, if no hole
exists, drill a ½” diameter hole. Insert grommet into
hole.
Note: Make sure not to damage any components
on either side of the frewall while drilling.
2. Find a path for the cable through the engine
compartment to the frewall. Use wire ties to secure
the cable. Make sure to avoid any hot or moving
engine parts.
3. Insert the cable into the grommet and pull the
excess slack into the driver’s compartment. Seal
around and inside of the grommet with silicone
sealant.
4. Plug the cable into the Patriot® Brake.
Note: When not in use, the cable can be tucked
away .
Method 2: Feeding the cable through the door/
window
1. Find a path for the cable through the engine
compartment to the rear of the hood/base of the
windshield, on the driver’s side. Use nylon ties to
secure the cable so that it is avoiding any hot or
moving engine parts.
2. Either roll down the window and thread the cable
through, or open the door and thread the cable
through. Make sure excess slack is safely coiled
inside the driver’s cockpit. Once the cable is
through and connected, close the door/window.
Installation
This section will explain how to install the breakaway.
Breakaway System
Description of your product.
The Breakaway system automatically activates the Patriot® to apply the brakes on your towed vehicle in the event
the motorhome separates from the towed vehicle. This type of emergency system is required by most states and
provinces.