Blue Ox BX8870 - Manual (Page 2)

INSTALLATION / STORAGE
DO NOT INSTALL, OR USE THIS EQUIPMENT UNTIL THE FOLLOWING
OPERATING AND INSTALLATION INSTRUCTIONS HAVE BEEN READ AND UNDERSTOOD.
The installation and storage instructions below are designed for everyday use. If installing your KarGard TM
for the first time, refer to the detailed instructions for specific tow bars found on pages 2-6. Due to vast
differences in towed vehicle front ends, these detailed instructions may have to be adjusted slightly or different
mounting holes used than those referred to in the instructions and on the illustrations. If your tow bar is not
specifically addressed, you should be able to adapt one of these sets of detailed instructions to aid in your
particular installation.
To mount this KarGard to a RoadMaster ® StowMaster ® tow bar, an adapter kit (BX8871) is required, which
can be purchased from your local Blue Ox dealer.
Page 2 of 12 292-1813 Rev. E 4/20/09
✁ IMPORTANT ✁
Note that the plastic material extends 12" beyond the rigid aluminum framework. This allows flexibility if you
should turn too sharp and the motorhomes' bumper or roof access ladder hits the KarGard.
A recessed receiver, a short tow bar, or both, will greatly reduce the turning radius, especially if you have a
roof access ladder on your motorhome. Be aware of this and check it the first time you turn a corner.
INSTALLATION FOR TOWING
1. Hook up your tow bar for towing.
2. Remove the locking rod and unfold the KarGard.
Remove the tower assemblies from their storage
slots and install them into the tower bases. Pin
them in place using the spring lock pins.
3. Insert the locking rod into the center hinges to keep
the KarGard straight.
4. Set the KarGard onto the dowel pins (bottom first)
then install the hair pins into the upper dowel pins
to secure the KarGard in place.
5. The KarGard is installed and ready for towing.
REMOVAL FOR STORAGE
1. Pull the hair pins from the dowel pins and remove
the KarGard. Lay it flat on the grass to avoid
scratching the surface. (aluminum angles up) Insert
the hair pins into the dowel pin holes to prevent
loss.
2. Remove the spring lock pins and towers from the
tower bases. Insert the spring lock pins through the
storage holes in the top of the tower assemblies.
By using these holes, the tower assemblies will not
slide out when stored inside the folded KarGard.
3. Lay the tower assemblies in the storage slots in the
aluminum angles. Arrange them so you know
which tower goes to which side to help avoid
confusion when installing the KarGard next time.
4. Remove the locking rod, fold the KarGard then
insert the locking rod to keep the KarGard folded.
5. Once folded, the locking rod or small aluminum
angle at the hinged end can serve as a handle.
STORAGE
The edges of the KarGard may warp slightly during
shipping or storage. When laid flat or installed on the
towers, the KarGard should regain its original form. We
recommend storing the KarGard folded, and laying flat.
NOTE: The material used in the construction of the
KarGard has a good memory of its original shape.
However, if the KarGard is subjected to abnormal
circumstances causing it to be bent sharply, it may not
regain its original shape. The manufacturer accepts no
responsibility for any damage caused to the KarGard or
to the towed vehicle resulting from the misuse of this
product.