Caution – Concord ABSORBER XT INSTRUCTION MANUAL User Manual
Page 8
30
31
_ REMOVinG THE COnCORD aBSORBER WiTH
THE THREE-POinT SaFETY BElT
Press and hold the seat tilt control (
07
)
upwards and move the seat part into its
front-most position.
Push the release button (
10
) outward
and move the support leg (
11
) into its
top-most position.
Open the harness clip for the shoulder belt (
12
) on the
side by pressing the control button on the harness clip
(
05
).
Open the belt lock of the lap and diagonal seat belt, and
pull it out between the seat part and the base of the
CONCORD ABSORBER.
CaUTiOn
!
• The lap and diagonal seat belt must
be lying flat and fully tensioned along
the base of the CONCORD ABSORBER.
• The seat belts must not be twisted.
• The shoulder harness must be inserted
in the harness clip (
12
) and tightened.
• The harness clip must be engaged and
closed tightly.
• The support leg must rest securely on
the floor and must be locked in place.
Check the correct position of the seat belts before each use.
Please contact CONCORD directly if you have problems mounting the seat.
The seat belts must run through the belt guides marked in red on the seat.
The seat belt must not be laid out in any other way.