Dunlop Manufacturing ZW45 - Manual (Page 2)

POWER
The Zakk Wylde Signature Cry Baby ® Wah Wah
is powered by one 9-volt battery (accessed via
the bottom of the pedal), an AC adapter such
as the Dunlop ECB003/ECB003E, or a DC
Brick
™ power supply.
SETUP INSTRUCTIONS
• Run an instrument cable from your guitar to
the ZW45’s INSTRUMENT jack.
• Run another instrument cable from
the ZW45’s AMPLIFIER jack to your
amplifier input.
• Turn on the amplifier and begin playing.
• To turn the pedal on/off, push the toe of
the pedal down until you feel a “click.”
• Located under the rocker at the heel of the
pedal is an adjustable torque clutch that
allows the amount of resistance the rocker
has to being moved. Turn clockwise to
increase resistance or counterclockwise to
decrease resistance. (Wrench included).
See Diagram A
SPECIFICATIONS
Impedance
Input 1 MΩ
Output 10 kΩ
Filter Center Frequency
Heel Down 250 Hz to 350 Hz
Toe Down 400 Hz to 2.4 kHz
Maximum Level at Center Frequency
Input -9 dBV
Output +6 dBV
Maximum Gain
Heel Down +17 dB
Toe Down +17 dB
Noise Floor *
Heel Down -100 dBV
Toe Down -90 dBV
Bypass Hardwire
Current Draw
900 uA
Power Supply 9 volts DC
*V
REF
=1V
RMS , A-weighted
ZW45 ZAKK WYLDE CRY BABY
®
WAH WAH
Diagram A