Dunlop Manufacturing DCR2SR User Manual
Page 2
POWER
The Crybaby DCR-2SR is powered by the Dunlop 35A adapter (QQQ in Europe), a 20-volt DC
regulated AC adapter. Plug polarity is positive on the barrel and negative on the center. Note: An
AC adapter must be used to operate the DCR-2SR.
FRONT PANEL
Volume switch selects optional volume pedal control
Wah switch engages wah effect
Six-position Range knob selects frequency range for wah effect
Q Control adjusts the frequency breadth of effect, from narrow and sharp to broad and subtle
Boost knob sets preset volume boost, up to +10dB
EQ switch selects 6-band EQ with each knob delivering +/-15 dB
BACK PANEL
Ground Lift switch
Remote On/Off switch jack
Control Pedal Input jacks
Output jack connects to amplifier
Wah Thru jack passes dry, uneffected signal
Input jack connects to guitar
Control Pedal, Input, and Output jacks for optional volume pedal
BACK PANEL
TROUBLESHOOTING
Problem: No sound is produced.
Solution: Check to see that all the connections have been properly made and
that the Crybaby Rack Wah is powered up and turned on. If optional Volume
pedal is being used, make sure the pedal is in the toe-down position.
Problem: I hear dry guitar, but no wah effect.
Solution: Make sure the proper connections have been made and that a
DCR-1SR Foot Controller is plugged into Control Pedal Input 1. Next, make
sure that the Wah button on the front panel is depressed. Also, make sure
the toe switch of the Foot Controller is activated with a click when you step
on the pedal—newer pedals can take a little extra pressure to engage.
Problem: The EQ doesn’t seem to be doing anything.
Solution: Make sure the EQ button on the front panel is depressed.
Problem: There is a lot of noise when I turn the Wah on.
Solution: Back off on the Boost and EQ settings. Extreme settings will add a
tremendous amount of gain and raise the noise floor.
POWER
The Crybaby DCR-2SR is powered by the Dunlop ECB007*, a 20-volt DC
regulated AC adapter. Plug polarity is positive on the barrel and negative on
the center. Note: An AC adapter must be used to operate the DCR-2SR.
*ECB007UK (United Kingdom)
*ECB007EU (Europe)
*ECB007AU (Australia)
FRONT PANEL
C U S T O M S H O P
®