High Lifter Lift Kit for Yamaha 550_700 Grizzly (07-14) - Signature Series - Manual (Page 5)

Rear Lift
1) Place jack under the center of the ATV, just forward of where the rear drive shaft connects to the
engine, and lift until the weight is off the suspension. Be careful to secure the ATV properly so it is
stable on the jack.
2) Remove the rear wheels.
3) Before you start the lift kit installation you need to reroute the rear brake lines. Remove the plastic
line cover located in the rear knuckle.
4) Next, disconnect the plastic tabs holding the lines to the A-arms. Flip them to where the lines run to
the inside of the A-arm and not the out side. Do this for both sides.