High Lifter Lift Kit for Honda 300 4x4 (98-02) - Manual (Page 4)

7. Next place the support bracket on the outside of the Front Lift Bracket. Make sure that it is on the side that
faces the rear of the ATV and secure it using one 10mm lock nut. Attach the other end of the support bracket to
two of the Support Attachment Brackets. “Sandwich” the A-arm frame using the Support Attachment Brackets,
two ¼ x 1 ¾ bolts and two ¼” lock nuts.
NOTE: The support bracket will bend and conform to the angle of the support attachment.
Rear
8. Tighten all bolts.
Make sure all bolts are tightening to manufacturer’s torque specifications.
Note: Some of the brackets may bend when they are tightened.
9. Repeat the procedure for the other side.
10. Install the wheels, torque wheel lug nuts to manufacturer’s specifications, lower and remove jack. Check for
clearance problems or misalignment.
11. Once the installation if complete, front and rear, ride the ATV to check steering and alignment. If steering is
aggressive you may need to adjust the toe on the ATV. Check the owner’s manual on adjusting the toe of your
ATV.