High Lifter DynoJet Jet Kit for Yamaha Wolverine 350 (94-95) - Manual (Page 2)

1. Remove top carb plate. Remove the slide lift arm screw and the two needle plate screws. Flip the linkage forward and remove the slide (Fig. A).
2. Install Dynojet needle on groove#3 for applications below 5000 feet, groove #2 for above 5000 feet, using all stock spacers. Install the Dynojet
washer above the E-clip.
3. Remove stock main jet and replace with Dynojet main provided. If you are running the stock exhaust use the DJ120 below 3000 feet, DJ116 from
3000 to 6000 feet and DJ112 above 6000Feet. If you are running an aftermarket exhaust, use the DJ122 below 3000 feet, DJ118 from 3000 to
6000 feet and DJ114 above 6000 feet. Be sure that the jet you are changing is the main jet.
4. Locate the Fuel Mixture Screw. Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 2 turns below 5000 feet
or 1 1/2 above 5000 feet.
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q402.001
Fig.B Fig. A
Remove slide
plate screws
Remove
screw and lift
arm
Fuel Mixture Screw
NOTE: If you have a bike with serial number 4KB-000101 ~ 002802, you must
have the carburetor update installed prior to installing this kit. Your local
Yamaha dealer will have this update on file as Bulletin MF94-004.