High Lifter DynoJet Jet Kit for Kawasaki Bayou 300 (91-04) - Manual (Page 2)

1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly.
2. Drill slide lift hole with DD32 drill bit supplied.
3. Install Dynojet needle on groove# 4 for applications below 5000 feet, groove #3 for above 5000 feet, using all stock spacers. Install the Dynojet
washers above the E-clip.
4. Remove stock main jet and replace with Dynojet main provided. Use the DJ118 below 3000 feet, DJ114 from 3000 to 6000 feet and DJ110 above
6000Feet. Be sure that the jet you are changing is the main jet.
5. Locate the Fuel Mixture Screw. Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 1 1/2 turns .
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q203.001
Fig. A
Fig. B
Fuel Mixture Screw