High Lifter Lift Kit for Can-Am Outlander - Signature Series - Manual (Page 5)

Rear Lift Installation
1. Place ATV transmission in park. Place jack under center of ATV rear end and lift until rear wheels clear
the ground. Be careful to support ATV properly so that it is securely supported so that the suspension
can droop to full extension.
2. Remove rear wheels.
3. Starting with the LEFT side remove top of the rear shock.
NOTE: VERY IMPORTANT WHEN DISCONNECTING THE SHOCK FROM THE FRAME DO
NOT LET THE CONTROL ARM DROP SUDDENLY. THIS CAN CAUSE THE AXLE TO PULL
OUT FROM THE DIFFERENTIAL.
4. Once you have disconnected the top of the shock from the frame, you will need to enlarge the bolt hole
on the driver’s (Left) side to accommodate the 5/16 x 2 ½ hex head bolt. Use a 5/16 drill bit to this.
5. Insert one 10x 65mm hex bolt thru one of the right lift brackets, and then place the small rear spacer into
the stock shock mount location. Insert the bolt thru the shock mount and spacer.