High Lifter DynoJet Jet Kit for Kawasaki Bayou 250 (02-11) - Manual (Page 2)

STAGE ONE INSTRUCTIONS
1. Unscrew the carb top. Disconnect throttle cable and remove the slide. Remove needle retainer (Fig.A).
2. Install Dynojet needle on groove #2 for applications below 5000 feet, groove #1 for above 5000 feet, using
all stock spacers. Install the Dynojet washer above the E-clip.
3. Remove stock main jet and replace with Dynojet main provided. Use the DJ106 below 3000 feet, DJ102
from 3000 to 6000 feet and DJ098 above 6000 feet. NOTE: Do not reinstall the plastic main jet cup. Be sure
that the jet you are changing is the main jet.
4. Locate the Fuel Mixture Screw (Fig.B). If you see a screw head at Fig.B then proceed to the adjusting
procedure. With the 5/32 drill bit provided carefully drill through the plug. NOTE: The mixture screw is directly
underneath this plug, be ready to pull back on the drill the instant you break through. Use the screw provided
to secure and remove this plug. Carefully turn the mixture screw clockwise until lightly seated, then turn out
3.5 turns, 3 turns above 5000 feet.
Fig.A
Q212.002
This is Groove # 1
Fig.B
Mixture Screw