High Lifter Lift Kit for Suzuki Eiger 400 2x4, 4x4 (02-07) - Manual (Page 2)

Front Lift Parts Diagram and Instructions
**Note** Sides of the ATV are described as if sitting on the ATV.
1. Place jack under center of the ATV front end and lift until front wheels clear the ground. Be careful to support ATV properly
so that it’s secure, but so that the A-arms and shocks can droop to full extension.
2. Remove front wheels and shocks.
3. Place Front Tube Bracket (small) onto shock mount. Make sure that the angle side is facing to the inside of the ATV.
4. Put large spacer into the shock mount.
5. Now insert the 10x55mm bolt into the brackets, aligning the holes, BUT do not go all the way through. Between the shock
mount and the inside of the bracket that is facing the front of the ATV insert two10mm washers.
6. Push bolt through fasten tight with the 10mm lock nut.
7. Place the bottom of the shock into the top of the Front Tube Bracket. Position the shock, so that it is on the inside of the tube
bracket so that is flush against the side of the bracket that is facing the rear.
8. Place the Large Front Flat bracket, on the side of the tube bracket that is facing the rear, with the large hole end next to the
tube bracket.
9. Insert the 10x55mm bolt, starting from the side that is facing the rear. Do not go all the way through. Between the shock and
the inside of the tube bracket insert a 10mm washer and small spacer. The washer needs to be between the small spacer and
shock.
10. Finish pushing the bolt through and fasten tight with the 10mm lock nut. Reattach the top of the shock to the ATV.
11. Secure the Large Front Bracket to the ATV’s A-arm, by inserting the two ¼ x 2 ¼ bolts and positioning the A-arm between
them. Insert the bolts from the side of the bracket that is facing the rear.
12. Place the Small Front Flat Bracket onto the two ¼” x 2 ¼” bolts and fasten tight with two ¼” lock nuts.
13. Repeat steps for opposite side. Torque all bolts to factory specifications. Place wheels on AVT and lower jack.
2