High Lifter Lift Kit for Arctic Cat Prowler 1000 - Manual (Page 6)

6
Rear Lift Installation
1) Place UTV transmission in park. Place jack under center of UTV front end and lift until front
wheels clear the ground. Be careful to support UTV properly so that it is securely supported so
that A-arms and shocks can droop to full extension.
2) Remove rear wheels.
3) Follow the previous steps for installing the spring spacers.
4) Once you have installed the spring spacers onto the shocks attach the top of the shock to the UTV.
5) Next connect the lift brackets to the control arm.
6) Place one left lift bracket next to the shock mount and place one spacer into the shock mount tabs.
Now insert a 10 x 65mm bolt to hold the bracket and spacer in place.
7) Insert another 10 x 65mm hex bolt through the top of the lift bracket and place two 10mm flat
washers onto the bolt.