High Lifter Lift Kit for Suzuki Twin Peaks 700 - Manual (Page 2)

Front Lift
1) Place jack under center of ATV front end and lift until front wheels clear the ground. Be careful to
support ATV properly so that it is securely supported but so that A-arms and shocks can droop to
full extension.
2) Remove front wheels.
3) Remove or loosen front plastic.
4) Remove C-clip and nut at the top of the strut.
5) Screw bracket “A” on top of strut to the same torque specifications as the nut.
6) Place the top adapter “A” through the top of the strut mount, and screw the original nut on the top of
bracket “A” securing it to the strut mount. Tighten this nut to the required manufacturer
specifications and replace the factory C-clip.
7) Repeat the procedure for the other side.
8) Install the wheels, torque wheel lug nuts to manufacturer’s specifications, lower and remove jack.
Check for clearance problems or misalignment.
Rear Lift
1) Place jack under ATV at the rear of the bottom skid plate and lift until the weight is off of the
suspension. Be careful to secure the ATV properly so as not to fall off the jack.
2) Remove the bottom of the shock from the shock mount on the axle.
3) After removing the shock, jack the ATV up 1”-2” further.
4) Place Bracket “B” between the shock and shock mount with the notched out ends facing downward.
Insert stock bolt to secure bracket “B” to the shock mount and the shock. Fasten nut.
5) Insert the new 12x75mm Bolt to the top of bracket “B” and the shock eyelet and secure with a new
12mm nut.
6) Tighten all nuts and bolts to manufacturer’s torque specifications.
7) Install the wheels, torque wheel lug nuts to manufacturer’s specifications, lower and remove jack.
Check for clearance problems or misalignment.