High Lifter DynoJet Jet Kit for Kawasaki Prairie 360 (02-13) - Manual (Page 2)

STAGE ONE INSTRUCTIONS
1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly (Fig.A).
2. Install Dynojet needle on groove #3 for applications below 5000 feet, groove #2 for above 5000 feet, using
all stock spacers. Install the Dynojet washers above the E-clip (Fig.A).
3. Remove stock main jet and replace with Dynojet main jet provided. Use the DJ150 below 3000 feet, DJ146
from 3000 to 6000 feet and DJ142 above 6000 feet. When using an aftermarket exhaust with a high flow
baffle, u se the DJ155 below 3000 feet, DJ150 from 3000 to 6000 feet and the DJ146 above 6000 feet.
4. Locate the Fuel Mixture Screw (Fig.B). If you see a screw head at Fig.B then proceed to the adjusting
procedure. With the 5/32 drill bit provided carefully drill through the plug. NOTE: The mixture screw is directly
underneath this plug, be ready to pull back on the drill the instant you break through. Use the screw provided
to secure and remove this plug. Carefully turn the mixture screw clockwise until lightly seated, then turn out
2.5 turns, 2 turns above 5000 feet.
Fig.A
Q211.002
This is Groove # 1
Fig.B
Mixture Screw
Main Jet
Dynojet Parts