High Lifter DynoJet Jet Kit for Polaris Sportsman 500 (99-00) User Manual
Page 2
1. Remove vacuum slide from the carb. Remove stock needles & spacers, noting order of assembly (Fig. A).
2. Install Dynojet needle on groove#4 for applications below 3000 feet, groove #3 for above 3000 feet, using all stock spacers. Install the Dynojet
washer above the E-clip.
3. Remove stock main jet. If you are running the stock exhaust use the DJ155 below 3000 feet, DJ150 from 3000 to 6000 feet and DJ146 above
6000Feet. If you are running an aftermarket exhaust, use the DJ160 below 3000 feet, DJ155 from 3000 to 6000 feet and DJ150 above 6000 feet.
Be sure that the jet you are changing is the main jet.
4. Locate the Fuel Mixture Screw (Fig.B). Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 3 turns below
3000 feet or 2 1/2 above 3000 feet.
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q505.001
Fig. A
Fig. B
Dynojet supplied parts.
Stock parts