Vitek VT-3525 SR - Manual (Page 10)

ENGLISH
10
- Select the place on the wall to mount
the clock with radio.
- Hang up the wall bracket using 4
screws and rods (Fig. 2).
- Hang up the clock on the bracket and
make sure that the power cord and
FM antenna go separately outside the
bracket.
- Turn the bracket screw into the clock
bottom (Fig.3).
- Check again that the wall bracket and
the device are firmly attached to the
wall.
Specifications
Frequency bands: AM 530 – 1600 KHz
FM 88 – 108 MHz
Output power: 280 mW
Dynamic’s impedance: 8 Ohm
Back-up battery: 1 flat lithium battery CR
2032 3V (not included)
Dimensions: 20 х 3.2 sm diameter
Power source: AC 230 V ~ 50 Hz
Power consumption: 5 W
Specifications subject to change without
prior notice.
MINIMUM SERVICE LIFE - 3 YEARS
GUARANTEE
Details regarding guarantee conditions
can be obtained from the dealer from
whom the appliance was purchased. The
bill of sale or receipt must be produced
when making any claim under the terms
of this guarantee.
This product conforms to
the EMC-Requirements as
laid down by the Council
Directive 89/336/EEC and to
the Law Voltage Regulation
(73/23 EEC)
3525.indd 10 3525.indd 10 26.07.2006 11:45:09 26.07.2006 11:45:09