M&C TechGroup SP35-H... Operator's manual - Manual (Page 12)

12
Gas sampling and gas conditioning technology 2-1.9.6ME
Figure 4 Electrical connection e.g. SP30-H2 with PT100
For executions with thermocouple the temperature sensor is also connected to terminals 7 and 8.
13 STARTING
W A R N I N G !
Before starting up check whether the mains power supply
voltage corresponds with the information stated on the
nameplate.
W A R N I N G !
Start up only the built-in heated probe tube because otherwise
there is a risk of burning !
The following step-by-step procedure is recommended :

Check temperature set value at external controller.

Switch on mains power supply.

The heated sample tubes are ready for operation after 2 hours heat-up time.