Vitek VT-3549 SR - Manual (Page 9)

ENGLISH
9
HOW TO USE AND SCAN THE MOON PHASE
Unit is equipped with a moon phase display and scanner with which eight moon phases
are displayed on the screen from new moon to waning crescent. The one falls on the
current day will flash on the screen.
If it is a full moon or new moon day, the icon will flash faster.
The eight phases are:
New Moon
Waning
Crescent
First Quar-
ter
Waxing
Gibbous
Full Moon
Waning
Gibbous
Last Quar-
ter
Waning
Crescent
To check the moon phase for a particular day, press the UP or DOWN button once. The
clock will enter moon phase scanning mode.
Use the UP or DOWN button to locate the date you want to check. The calendar will be
day-driven in this mode.
You can go back 39 days travel to next 39 days.
The corresponding moon phase will appear immediately on the screen.
The unit will return to the last display mode when the UP and DOWN buttons are left
idle for 2 seconds.
DISCONNECTED SIGNALS
If without obvious reasons the display of the outdoor temperature goes blank, Hold [-]
for 2 seconds to enforce an immediate search.
If that fails, check:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main unit.
Replace as necessary.
Note: When the temperature falls below freezing point, the batteries of outdoor
units will freeze, lowering their voltage supply and the effective range.
3. The transmission is within range and path is clear of obstacles and interference.
Shorten the distance when necessary.
TRANSMISSION COLLISION
Signals from other household devices, such as door bells, home security systems and
entry controls, may interfere with those of this product and cause temporarily recep-
tion failure.
This is normal and does not affect the general performance of the product. The trans-
mission and reception of temperature readings will resume once the interference re-
cedes.
3549.indd 9 49.indd 9 02.06.2006 16:59:37 02.06.2006 16:59:37