Naxa NI-3108 - Manual (Page 3)

LOCATION OF CONTROLS
1 POWER Button 11 Speaker
2 SKIP+/TUNE+ Button 12 DC In Jack
3 PLAY/PAUSE/M+ Button 13 Video Out Jack
4 SKIP-/TUNE- Button 14 Aux-In Jack
5 VOL+ Button 15 Rod Antenna
6 VOL- Button 16 Battery Compartment
7 SOURCE Button
8 CLOCK SET/MEM Button
9 iPHONE/iPOD Docking Port
10 LCD Display
- 4 -
CONNECTING THE UNIT TO POWER
Plug one end of the AC/DC adaptor into the DC-In jack, and then plug the other end into AC wall outlet.
Before switching on the unit, make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
BATTERY OPERATION
Disconnect the AC Cord Set completely. Open the Battery Compartment Door and insert 6 pieces UM-2
"C" size batteries into the battery compartment with battery polarity as shown inside the battery
compartment.
SETTING THE TIME
Before starting to set the time, make sure that the unit is in POWER OFF Mode
1. Press and hold the MEM/CLK SET button for approx. 1 second, the hour digit in the clock display
will start flashing.
2. Use the SKIP+/TUNE+ or SKIP-/TUNE- button to adjust the hour.
3. When the correct hour is selected, press the MEM/CLK SET button again to enter the minute mode
with minute digit flashing.
4. Press the SKIP+/TUNE+ or SKIP-/TUNE- button to adjust the minute.
5. When the correct time is selected, press the MEM/CLK SET button to store the time in the memory.
RADIO OPERATION
1.
Press the POWER button to turn on the unit.
2. Press the SOURCE button to select the FM Radio mode. FM will show in the LCD display.
3. Press and hold the SKIP+/TUNE+ or SKIP-/TUNE- button for approx. 1 second, it will start to search
the next radio station in the direction of the search. The search operation simply finds stations with
strong signals. Stations with weak signal can only be tuned in manually.
4. Use the VOL+ or VOL- button to adjust the volume to the desired listening level.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM stations. For AM reception, the unit has a
built-in antenna, turn the whole unit for best reception.
SAVING RADIO STATIONS IN THE MEMORY
1.
Tune to the desired stations.
2. Press the MEM CLK SET button, the display will show the next memory station number and
flashing.
3. Use the SKIP+/TUNE+ or SKIP-/TUNE- button to select memory number, then press MEM CLK
SET button again to store the station into the memory.
4. Repeat step 1 to 3 to store more radio stations in the memory.
5. Up to maximum 20 radio stations can be stored in the memory.
TO SELECT A STORED RADIO STATION IN THE MEMORY
Press the PLAY/PAUSE/M+ button to select the next stored radio station.
- 5 -