Naxa NI-3103A - Manual (Page 12)

12
unit. The unit’s speakers will deactivate.
WARNING: Avoid prolonged exposure to high sound levels, as this may cause
permanent hearing damage.
Care and Maintenance
Clean the product with a soft cloth; do not use liquids or abrasive chemicals or pads.
Troubleshooting
PROBLEM PROBABLE CAUSE RESOLUTION
No sound
• The volume is set too low.
• A headphone (or earphone is
plugged into the unit.
• The iPod is not inserted
properly.
• The iPod is paused or in the
Hold position.
• The IPod may need to be
reset.
• Increase the volume by pressing
the VOL+ side of the Volume
Button.
• Unplug the headphone (or
earphone).
• Remove and reinsert the
iPod/iPhone.
• Switch the iPod/iPhone from
the Pause or Hold position.
• Reset the iPod/iPhone as
instructed by the device
manufacturer’s instructions.
Distorted
sound
• The volume level is too high.
• The song file is distorted.
• Decrease the volume of the unit
or of the device.
• Skip to another song file.
Unit warm
after
lengthy
play.
• This is acceptable, especially
if the volume is at a high level.
• Lower the volume or turn off
the unit until cool.
No power
• The Insert is not securely
connected.
• The electrical outlet is not
operational.
• Ensure the Adapter is securely
connected to both the Jack and
to the electrical outlet.
• Ensure the unit is plugged into
an operating electrical outlet.
No power -
Remote
Control
• The transmitter on the front of
the Remote or the sensor on
the front of the unit is
blocked.
• Remove any material or dirt
from the transmitter or sensor.
• Replace the batteries as
instructed by the “Battery