Naxa NPB-251 - Manual (Page 6)

E-5
Avoid installing the unit in locations described below:
•
Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters.
•
Dusty places.
• Places subject to constant vibration.
• Humid or moist places.
POWER SOURCES
This unit operates on 120V~ 60Hz or 6 x DC1.5V “C” (UM-2) batteries. Do not attempt to operate the radio
on any other power source. You could cause damage to the unit and void your warranty.
Please be sure the power outlet you plug this unit into is working and receives constant (unswitched) power.
AC OPERATION
1. When the AC power cord (included) is connected to the AC Power Socket on the back of the unit and the
other end is plugged into a 120V AC~ 60Hz wall outlet, the unit will disconnect the batteries automatically,
and operate on AC Power only.
2. Slide the FUNCTION SWITCH to “CD” for CD play, “FM” or “FM ST.” for FM radio, “AM” for AM radio
and “OFF” for unit to switch off.
BATTERY OPERATION
1. Remove the BATTERY DOOR.
2. Install 6 x DC1.5V “C” (UM-2) batteries (not included) according to the polarity diagram inside the battery
compartment.
3. Close the BATTERY DOOR.
IMPORTANT:
Be sure that the batteries are installed correctly.
Wrong polarity may damage the unit and void the warranty.
For best performance and longer operating time, we recommend the use of good quality
alkaline-type batteries.
CAUTION
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
3. If the unit is not to be used for an extended period of time, remove the battery. Old or leaking batteries can
cause damage to the unit and may void the warranty.
4. Do not dispose of batteries in fire, batteries may explode or leak.
BATTERY REPLACEMENT
When the output sound of this unit becomes distorted or the CD player operation appears unstable, the
batteries are weak. You need to replace all the exhausted batteries at the same time as soon as possible to
avoid battery leakage.
RADIO OPERATION
1. Slide the FUNCTION SWITCH to “RADIO”.
2. Select your desired radio band using the BAND SELECTOR for AM/FM or FM Stereo.
3. Rotate the TUNING CONTROL to your desired radio station according to the DIAL SCALE on the unit.
4. Rotate the VOLUME CONTROL to adjust to the desired output level.
5. To turn off the radio, slide the FUNCTION SWITCH to “OFF”.
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change the position
of unit until the internal antenna picks up the strongest signal.
FM – If a stereo broadcast program is being received, the FM STEREO INDCATOR will light. During FM or
FM Stereo reception, always keep the FM TELESCOPIC ANTENNA fully extended for best
performance. However, if FM reception is weak, try repositioning the unit near an open window until
you get the best reception.