Naxa ND-853 - Manual (Page 17)

-16-
SYSTEM SETUP
2.If TV system is selected, press the Direction button to enter. Press the Direction buttons , to select the
format of output signals to NTSC,PAL or AUTO. Then press the Enter button to confirm your selections.
Press the SETUP button to save the setting and exit.
Set it to P if the color system of your TV is PAL. AL
Set it to AUTO if the color system of your TV is multi-system.
Notes:
Set it to NTSC if the color system of your TV is NTSC. (Default setting. The TV signals in US, Canada and
Mexico is NTSC).
select video output modes to
Notes:
~ Set to if you connect the TV via the AV jack on the player and
jacks on the TV as the figure on page 10.
~ Set to YUV if you connect the TV via the YUV jack on the player and YUV IN jacks on the TV as the
figure on page 9.
~ Set to Ypbpr if you connect the TV via the YUV jack on the player and YUV IN jacks on the TV (TV also
set to Progressive Video input mode) as the figure on page 9.
S-VIDEO,YUV or Ypbpr as the connections of the TV.
S-VIDEO or S-Video S-Video IN
3.If Video out is selected, press the Direction button to enter. Press the Direction buttons , to
1. If Use Default is selected, press the Enter button to confirm,press to selection the Direction button select Yes
or NO then press the ENTER button to confirm.
Notes:
~ If Yes is selected, the settings in the setting menu will be reset to default settings. (Except rating level settings).
~ If No is selected, exit without any changes.
In Misc (Miscellaneous) Setup Page:
Press the Direction buttons , to select Use Default setting or Screen saver as desire
then press the Enter button to enter.
2. If the Screen Saver is selected ►to enter. Press the Direction buttons , Press the Direction button ▲, ▼ to select
On or Off as desire then press the Enter button to confirm your selections.Press the SETUP button to save the setting
and exit. When set to On, the screen saver will come on when the unit stops or the image is paused for minutes. a few
When is Off, the screen saver will not come on. the settings
Digital Out
1. If Digital (selection the digital audio output format from the COAXIAL jack) is selected, press the Direction
button ►to enter. press the Direction buttons ▲,▼ to select “OFF”“PCM”or“RAW”to matching the decoding
system of your connected external audio amplifiers (For details,refer to the instruction manual of your external
amplifiers).
2. Press the SETUP button to save the setting and exit.
Output