Naxa NDL-252 - Manual (Page 5)

4
Basic connection
Ü
—
—
—
—
—
—
—
It is recommended to be connected to a multi-system TV.
Ensure that this player and other equipment to be connected
to the unit are in the standby or off mode and disconnect
the AC power cords before commencing connection.
Do not block ventilation holes of any piece of the equipment
and arrange them so that air can circulate freely.
Read through the instructions before connecting other
equipment.
Ensure that you observe the color coding when connecting
audio, video cables.
During DVD play, the TV volume may be at a lower level
than during TV broadcasts, etc. If this is the case, adjust the
volume to the desired level.
If the DVD/CD player is connected to the TV through a video
cassette recorder, the picture may not be played back
normally with some DVDs. If this is the case, do not connect
the player via the VCR.
Note:
The mains plug is used as disconnect device, the disconnect
device shall remain readily operable.
Connecting to a stereo TV set
To power outlet
AC power cord
1. FUNCTION button
2. P/N button
3. REPEAT A-B button
4. REPEAT 1/ALL button
5. MENU button
6. SUBTITLE button
7. PLAY button
8. TITLE button
9. AUDIO button
10. PAUSE/STEP button
11. F.BWD button
12. F.FWD button
13. ANGLE button
14. ZOOM button 15. DISPLAY button
16. SETUP button
17. MUTE button
18. NUMERIC buttons
19. CLEAR button
20. STOP button
21. SELECT button
22. NAVIGATION buttons
23. SLOW button
24. NEXT button
25. PREV button
26. SEARCH button
27. PROGRAM button
Remote control unit
To video input connector (yellow)
To audio input connectors (red, white)
Video/audio cable
R L
CONNECTING MICROPHONE
AND HEADPHONE
Connect one Microphone to MIC jack.
1
Connect the Microphone.
2
Adjust the MIC Volume to proper level that you
want.
3
Connect one headphone to phone jack.
2 1
3
+10 0
7
4
1
8
5
2
9
6
3
1/ALL
TITLE
AUDIO
F.BWD
ANGLE ZOOM
F.FWD PREV NEXT
SEARCH PROGRAM
PAUSE/STEP SLOW
SELECT
FUNCTION DISPLAY SETUP MUTE
REPEAT
MENU
SUBTITLE PLAY STOP
CLEAR
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
A-B
P/N
OPERATIONS
PREPARATION
Power on the TV set and select video input mode.
Power on the audio system which is connected to the player.
GET STARTED
ADJUST THE VOLUME
1. Turn on the player and switch the FUNCTION CONTROL to
DVD position.
2. Lift CD cover Open area to open the disc tray.
3. Place a disc onto the disc tray.
4. Close CD door by hand and the playback starts
automatically.
5. When a menu screen appears on the TV, move the navigation
buttons or press the numeric buttons to select a preferred track
number, then press SELECT button to start playback.
Rotate the VOLUME CONTROL key on the main unit to
increase or reduce the volume.
1 1