Spicer Kingpin Bushing and Seal Installation Instructions - Manual (Page 2)

7. Drive bushing until they are located at the depth indicated on figure 2. Use the same method to install both top
and bottom bushings.
Model Depth
E-1000I, E1000W, E-1200I, E-1200W 0.55"
E-1201W, E1203I, E-1320I, E-1320W
E-1460I, E-1460W, E1462I 0.40"
EFA-12F3, EFA-12F4 0.25"
EFA-13F3, EFA-13F5, EFA-18F3, 0.10"
EFA-20F4, EFA22T2, EFA22T5
EFA24T2, EFA24T5
Bushing
Recess bushing from the
bottom knuckle
surface.
Recess bushing from the top
knuckle surface.
Figure 2
8. Install new grease seal using the proper installation tool. When installing the seal be sure the lip is pointing
toward the center of the knuckle. See Figure 3 for seal position.
I
nstall
top seal
lip down
I
nstall
bottom
seal
lip up
Lip 0.060"
0.060"
Figure 3
For spec’ing or service assistance, call 1-800-
621-8084 24 hours a day, 7 days a week.
Or visit our web site at: http://www.
spicerparts.com
Dana Corporation
SHAIS130A Copyright Dana Corporation, 2001 Commercial Vehicle Axle Division
August 2001 All Rights Reserved. P.O. Box 321
Printed in U.S.A. www.dana.com
Toledo, Ohio 43697-0321