Spicer Dana Spicer Drive Axles - Manual (Page 5)

Model Identification
• Axle Housings are identified by the specification number stamped on the rear right hand side of the axle housing. This number
identifies all components of the axle as built by Spicer, including OEM special requirements such as yoke or flange. Some axles may
also include an identification tag as shown.
• These axles will be found with a number of different Axle Shafts, on the basis of OEM specification. When ordering replacement axle
shafts, note the part number stamped into the flange.
• The axles illustrated in this book are specified with a variety of different axle shafts, according to OEM specifications.
When ordering replacement axle shafts, note the part number stamped into the flange.
Using Model Designation to Identify Axle Components
• The Axle Model Identification number contains information that is important to understand when purchasing service parts or new
components. The Model Identification number provides important vehicle, capacity and application information and model features.
Use this guideline to understand your Axle Model Identification. If you need assistance, contact your
Spicer Field Marketing regional representative.