Spicer Carrier to Housing Leak Repair Procedure - Manual (Page 2)

Carrier Removal: Forward - Rear Axle
a. Disconnect the IAD shift cylinder airline.
b. Install carrier guide pins at 4:00 and 9:30 positions of housing mounting holes.
9:30
4:00
Install Carrier Guide Pins 4:00 and 9:30 positions
c. Remove power divider cap screws at 5:30 and 7:30 positions.
d. Position adapter plate. Adjust transmission jack table to align with power divider cover holes.
Note: There are some vehicles that may sit lower than others, if the adapter plate will not line up you may
need to jack the truck up and put it on jack stands.
D-Carrier Adapter Plate
Adapter Plate Position On Forward Carrier
e. Reinstall capscrews and snug with impact gun.
Warning: It is important that the adapter plate is properly secured and positioned on the transmission jack
before the carrier is removed.
f. Remove remaining carrier capscrew and carefully remove the carrier assembly. Use a large screw driver or pry
bar to back the carrier off the housing studs.
2