Spicer ES-165-10H - Manual (Page 2)

Fig. 2 Fig. 3
9. With emery cloth or file clean rust and debris from around the anchor pin bore area on the brake shoes. See Figure 2.
10. With emery cloth clean the anchor pin bushings in the shoe and the brake spider. See Figure 3.
Note: These areas should be cleaned sufficiently so the brake shoes install freely over the brake spider.
BRAKE SHOE AND ANCHOR PIN INSTALLATION PROCEDURE:
1. Install grease fitting in anchor pins and lubricate anchor pin surface and anchor pin bushings with a light film of grease
prior to installation in spider. See figure 4.
Fig. 4
Fig. 5
CAUTION: Use only grease conforming to NLGI grade #1, high-temperature, waterproof, Do Not Lubricate the
cam head surface. For efficient operation, this surface must remain free of oil, grease or other contaminants.
2. Lubricate roller recess of the shoes with a light coat of grease prior to installation
3. Place the upper shoe in position on the spider, and install upper anchor pin with the grease fitting toward the frame rail
of the vehicle. See Figure 5.
Note: The shoe should slide freely over the spider. If there is any interference grind or file the anchor pin area of
the shoe and the spider.
Fig. 6 (Frame side)
Fig. 7 (Drum side)