Spicer S110 User Manual
Page 2
Repair Instructions for S110 Wheel Seal Leaks on Ford Trucks – Shais167
6. Place the Speedi-Sleeve into the installation tool with the rolled lip facing outward as shown below.
Rolled Lip Should Face Outward
7. Place the sleeve/tool over the housing spindle. Ensure that the sleeve is aligned to the spindle and that the tool is
not cocked.
8. Using a dead-blow hammer, install the sleeve on to the spindle. The tool will bottom out on the spindle end when
the sleeve is in the correct position.
Install sleeve with Driver
Bottom Out Installation Tool
9. Install new wheel seals utilizing the appropriate seal driver.
Important note: Not using the appropriate CR Seal driver may result in improper seal installation.
10. Reinstall the hub assembly, bearings and wheel end nut system.
11. Set wheel endplay .001” to .005”.
For spec’ing or service assistance, call 1-800-
621-8084 24 hours a day, 7 days a week.
Or visit our web site at:
http://www.
Dana
Corporation
SHAIS167
Copyright
Dana
Corporation, 2005
Commercial Vehicle Axle Division
May 2005
All Rights Reserved.
P.O. Box
321
Printed in U.S.A.
Toledo, Ohio 43697-0321
2