Spicer Driveshafts Service Manual - Manual (Page 20)

17
Driveshaft
1. For Snap-Ring Style: Using snap-ring pliers,
remove all snap rings. If snap rings are severely cor-
roded or out-of-round, snap rings must be replaced.
1. For Quick Disconnect™ Style: Remove spring tab
bolts and discard, and remove outboard bearing cap
assemblies.
2. Make sure universal joints cross assembly is not
tilted in the yoke. Place bearing cup spacer onto the
base of the arbor press and under the yoke. If the
arbor is larger than the bearing cup diameter, a
smaller diameter push rod will be needed to avoid
damaging the yoke or bearing.
Snap-Ring Style
Quick Disconnect™ Style
Correct Positioning
Incorrect Positioning