Spicer Wheel Differential Bearing Inspection and Repair Process - Manual (Page 4)

Instructions: Staking Inspection and Restaking Procedure
1. A proper stake should penetrate the machined slots as deep as possible without cracking the ring. Both sides of
the adjuster ring should contact the edges of the machined slot. A poor stake will have a gap between the
adjuster ring and the machined slot, as show below.
2. If the adjuster needs to be restaked, with a round head punch, stake the outer edge of the retaining ring into the
machined slots on each side of the wheel differential bore.
For spec’ing or service assistance, call 1-800-
621-8084 24 hours a day, 7 days a week.
Or visit our web site at: http://www.
spicerparts.com
Dana Corporation
SHAIS182A Copyright Dana Corporation, 2008 Heavy Vehicle Technologies and Systems Service
June 2008 All Rights Reserved. P.O. Box
321
Printed in U.S.A. www.dana.com Toledo, Ohio 43697-0321
Good
Stake
Poor
Stake
Round Head Punch
Gap