Spicer Dana LMS Hub Assembly Procedure - Manual (Page 2)

WARNING: Do not attempt to make LMS™ hubs by using LMS™ bearing, spacer and seals in a standard hub.
This may result in a seal or bearing failure, which may result in loss of wheel end and or loss of vehicle control.
04/03 2 of 11 ABIB-0302
PARTS INFORMATION
IMPORTANT: This is a pre-adjusted wheel hub and bearing system. Components required are a special tight tolerance hub,
bearing spacer, bearings, oil bath seal, three or four-piece dowel-type nut system and identification tag.
Note: Purchase Genuine replacement Hub and Cup Assemblies through O.E.M.
Note: A special installation tool to hold outer bearing cone in place during assembly to spindle is recommended. This also
helps prevent cocking of the wheel seal that may occur during installation.
WARNING: LMS™ hub components are made to special tight tolerances. Installation and/or servicing with other
components will either create excessive endplay or cause excessive pre-load, reducing bearing and seal
performance. Wheel separation may also occur.
STEER AXLE PARTS LIST DRIVE AXLE PARTS LIST
Part Name Part Number Part Name Part Number
1 LMS™ Hub & Cup Assembly * 1 LMS™ Hub & Cup Assembly *
2 Half Stand Bearing Cone
Assemblies 129381
129384 2 Half Stand Bearing Cone
Assemblies 129375
129378
3 Bearing Spacer 129372 3 Bearing Spacer 129373
4 Oil Bath Wheel Seal 847 4 Oil Bath Wheel Seal 861
5 LMS™ Identification Tag 970576 5 LMS™ Identification Tag 129391
6 Inner Spindle Nut 815622 (Note: With LMS Hubcap there
7 Dowel Type Lock Washer 815623 will not be an identification tag.)
8 Tang-Type Lock Washer 817134 6 Inner Spindle Nut 119882
9 Outer Spindle Nut 815638 7 Dowel Type Lock Washer 119883
10 Gasket * 8 Tang-Type Lock Washer 129132
11 Hubcap * 9 Outer Spindle Nut 119881
12 Hubcap bolt *
*Contact vehicle OEM for specific part numbers.