Spicer Single Drive Axles Service Manual: Single Reduction & Single Reduction with Differential Lock User Manual
Service manual, Spicer, Single drive axles
Advertising
Spicer
®
Single Drive Axles
Service Manual
Single Reduction & Single Reduction
with Differential Lock
AXSM0048
September 2008
15040S
17060S/D
19050S
19055S/D
19060S/D
20060S/D/R
21060S/D
21065S/D
21090S/D
22060S/D/R
22065S/D
P20060S/D/R
P22060S/D/R
23070S/D
23080S/D
23085S/D
23090S/D
23105S/D
26080S/D
26085S/D
26090S/D
26105S/D
30105S/D
Advertising
Table of contents
Document Outline
- General Information
- Table of Contents - Visual
- Introduction
- Model Identification
- Parts Identification
- Ring Gear and Pinion
- Failure Analysis
- Prepare the Parts for Inspection
- Find the Cause of the Failure
- Correct the Cause of the Problem
- Inspect Assembly
- Clean
- Inspect Axle Housing
- Inspect Primary Gearing
- Differential Carrier Assembly - Exploded View
- Remove Differential Carrier
- Install Differential Carrier
- Disassemble Carrier Assembly - (Rear Axles)
- Rear Axle Pinion Assembly - Exploded View
- Remove Pinion Assembly
- Disassemble and Overhaul Drive Pinion
- Adjust Pinion Bearing Preload - (Trial Buildup)
- Adjust Pinion Bearing Preload - (Final Buildup)
- Install Drive Pinion Assembly
- Install Pinion Oil Seal and Yoke
- Yoke Reuse Guidelines
- Seal Replacement
- Wheel Differential - Exploded View
- Remove Wheel Differential - (All Standard Models)
- Disassemble, Overhaul and Assemble Wheel Differential
- Disassemble Wheel Differential
- Overhaul and Assemble Wheel Differential
- Measure and Adjust Carrier Assembly
- Adjust Backlash and Preload
- Adjust Ring and Pinion Tooth Contact Pattern
- New Gearing - Correct Pattern
- Used Gearing - Correct Pattern
- Adjust Contact Pattern
- Adjust Pinion Position
- Adjust Ring Gear Position (Backlash)
- Differential Lock Shifting Parts - Exploded View
- Type 1
- Type 2
- Wheel Differential Locking Axles
- Type 1
- Type 2
- Install and Adjust Differential Lock - Type 1 Axles
- Shift Fork Adjustment - Type 1 Axles
- Install and Adjust Differential Lock - Type 2 Axles
- Install and Adjust Wheel Differential Lock
- Install New Axle Housing Breather - (Metal and Plastic)
- Axle Housing - Exploded View
- Inter-Axle Speed Sensor Parts - Exploded View
- Disassemble and Overhaul Inter-Axle Speed Sensor
- Disassemble
- Overhaul
- Install Inter-Axle Speed Sensor
- Wheel End Seal Parts - Exploded View
- Remove and Overhaul Wheel End Seal
- Adjust Wheel Bearing
- Verify Wheel End-Play Procedure
- Lubrication Information
- Proper Vehicle Towing
- Towing of Axles Equipped with Wheel Dif ferential Lock
- Without Wheel Differential Lock
- Operate Wheel Differential Assembly
- Control Systems for Differential Lock
- Wheel Differential Lock
- Wheel Differential Lock Operation
- Rear Drive Axle Parts - Exploded View
- Inter-Axle Speed Sensor Parts - Exploded View
- Inter-Axle speed Sensor
- Wheel Differential Lock Assembly
- Housing and Output Shaft Assembly Parts - Exploded View
- Fastener Torque Specifications