Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 - Manual (Page 45)

Power Divider Replacement
42
Ser
vice Procedure
Install Power Divider on Differential Carrier
Special Instructions
Lubricate all parts before installation.
Procedure -
1. Axle Housing Cover and Output Shaft Bearing Parts. If
removed, install these parts following instructions on
page 27.
2. Output Shaft. If removed, lubricate "O" rings, then install
shaft assembly in differential carrier and housing cover.
Lubricate seal lip. Make sure yoke is clean and dry, then
install yoke, flat washer* and self-locking nut. Torque nut
to correct specification.
Note: Late Model Axles may be equipped with a spring
and thrust button mounted in end of output shaft.
3. Inter-axle Differential- Install this assembly on output
shaft side gear (with nuts facing away from side gear).
4. Power Divider Assembly- Use silicone rubber gasket
compound on differential carrier mating surface as shown
in the illustration.
Note: Compound will set in 20 minutes. Install power di-
vider before compound sets or reapply.
During installation of power divider, the inter-axle dif-
ferential may fall from carrier. Exert caution to prevent
damage or injury.
Silicone Gasket Compound
CAUTION