Velleman projects EDU05 Assembly instructions - Manual (Page 11)

EDU05 Test procedure & programming in Visual Basic 2010 ( Version 1.0)
11
D D i i s s a a b b l l i i n n g g / / E E n n a a b b l l i i n n g g t t h h e e S S t t a a r r t t - - u u p p d d e e m m o o
Disable the demo:
• Switch on “Disable Startup Demo”
• Disconnect the software
• Disconnect the USB cable of the board.
When you re-connect the USB cable you’ll see that demo has been disabled.
Enable the demo:
• Connect the USB cable with the board & PC *
• Run the “Test & diagnosis” software
• Connect the software
• Switch off “Disable Startup Demo”
* Because the start-up demo is disabled, you don’t need to press button “8” on the board to start the
communication with the PC.