Velleman К8068 - Manual (Page 8)

8
Installation & use
 Cut off the mains voltage of the K8006 (deactivate the main fuse of your switch box).
 Place the K8068 module into a free connector.
 Connect a load suitable for the specifications of this module !
You can now activate your K8006
Upon K8068 power-on, the LED (LD1) will flash briefly once (twice for 60Hz mains) during the internal diag-
nosis test. After this brief test, the module automatically switches to normal operation.
If the CPU detects irregularities during the self test or during operation, the module will switch to the ALARM
position. The status LED will slowly flash once, followed by a number of shorter flashes (see "LED error
indications ")
Use :
Press any control button briefly to switch the light source on or off, or keep the button pressed to adjust the
light intensity. When a dimming cycle reaches an end point (maximum luminosity or turned off), the dimming
cycle will halt automatically.
To reverse the dimming direction, release the button for a moment and keep it pressed again.
The last used light intensity is saved in the internal memory when the light source is switched off by briefly
pressing the control button. This light intensity is also saved in case of a power failure. For safety reasons,
the lamp will not switch on again after a power failure.
16. Installation & use