Velleman projects K5600R Assembly instructions - Manual (Page 14)

_______________________________________________________________________________________________________________________________________________________
14
14.MOUNTING INTO THE OPTIONAL HOUSING
A special housing can be ordered, type: B5600
•
Disassemble the housing by removing the front and side panels.
•
Drill a pass through hole into the housing where supply wire is desired (side,
back, top, bottom…).
•
In a master / slave configuration, drill also a pass through hole into the housing
where interconnection wires are needed.
•
An extra hole can be made, if easy access to the speed adjustment potenti-
ometer is desired.
•
Slide the PCB into the lower slot.
•
Slide in the side panels.
•
Mount the front panel.
!
IMPORTANT: If the unit is used with a power supply higher than 15V, then
ventilation holes must be made in the bottom and top part of the housing!