Velleman К8074 User Manual

Page 7

Advertising
background image

7

IMPORTANT:

Construct the antenna coil as described to make sure it complies with the effective

R&TTE directive.


Wind the antenna using the included copper wire.
Remove the lacquer from one side of the wire with a knife so the solder will hold.

Wind the antenna using a Ø 5mm drill bit (NOT 4mm or 6mm).
Make 7 windings and elongate until the antenna is 10mm long (see fig. and picture on the packaging).

Solder the coil in place.

12. ASSEMBLING THE ANTENNA

Refer to the user manual *

* Download the user manual from www.vellemanprojects.com

13. TEST

Construction

10mm

5mm

7

IMPORTANT:

Construct the antenna coil as described to make sure it complies with the effective

R&TTE directive.


Wind the antenna using the included copper wire.
Remove the lacquer from one side of the wire with a knife so the solder will hold.

Wind the antenna using a Ø 5mm drill bit (NOT 4mm or 6mm).
Make 7 windings and elongate until the antenna is 10mm long (see fig. and picture on the packaging).

Solder the coil in place.

12. ASSEMBLING THE ANTENNA

Refer to the user manual *

* Download the user manual from www.vellemanprojects.com

13. TEST

Construction

10mm

5mm

Advertising