Velleman VMB1BL - Manual (Page 9)

Velbus manual VMB1BL – edition 1 – rev.2.0
9
L H UP DWN
BUS
+
12V
-
COM L DOWN UP
TIME
ADDR
TERM
VELBUS
Direct push button control
(up and down)
12V supply
Up operation mode LED
Manuel up operation
Down operation mode LED
Up indication LED
Direct push button control
(COM connection)
Relay contacts for blind motor control
Forwarding LED
Reception LED
Power LED
Address setting
Switch-off setting
Termination
Down indication LED
Manuel down operation
OUT
PB
USE:
Remove the lid on the blind control module using a small screwdriver to modify the configuration.
Replace the lid.
Termination:
If the module is connected at the start or end of a cable on the VELBUS, place the ‘TERM’ jumper.
Remove the jumper in all other cases.
If different cable wiring topologies (tree, star, loop, ...) are used, place a jumper on the end module of the longest
cable only, NOT on each end point.