Velleman projects K8093 User manual - Manual (Page 10)

- 10 - - 11 -
R.
..
R.
..
R.
..
R. ..
R. ..
R.
..
R.
..
Driver installation & programs
IV. ARMINg ThE UNIT
Out of the box no remotes are assigned for safety reasons. When the unit powers up it is always armed!
Unit is capable of storing 4 remotes, FIFO.
The stored remotes can be cleared from memory by holding the LEARN button while powering up, The unit will beep 10 times
(fast) to indicate the erasing process.
STATUS INDICATION (LD3)
LEARNING A REMOTE:
1. Press the “Learn”-button once, the status LED light continious. The unit is ready for learning a remote (there is a timeout!).
2. Hold the 2 buttons of the remote pressed. Release the buttons when the status LED turns off , the remote is learned.
REMOTE CONTROL:
1. DISARM
2. ARM
Power
suppl
y
Relay
Door contact
gND*
(*) If you want to connect a 12V
siren directly to the relay you can
connect the +12V of the input volt-
age to the COM. Connect the nega-
tive lead of the siren to the leftmost
(-) connector and the positive to
the NC or NO contact of the relay.
III. CONNECTION DIAgRAM
���������������� ���������������������