Velleman VM162 - Manual (Page 5)

5
TRANSMITTER INSTRUCTIONS
Transmitter instructions
At first power-on, the unit will run in demo-mode. Every now and then, the colour will automatically change. As soon as a
transmitter is learned to the unit, the demo-mode will be deactivated. Returning to demo-mode is not possible.
The transmitter comes with a factory set default code, it can be desired to change the code:
Open the enclosure :
2. Return to the default code :
open
1. Hold SW1 (left button).
2. Briefly press the 'program'-button (SW3) 3 times.
The LED will flash 3 times.
3. Release SW1.
4. Your unique 32-bit code has been generated and stored.
1. Changing the code :
1. Hold SW1 (left button).
2. Hold the 'program'-button (SW3). After +/- 10s the led will flash 5 times.
3. Release both buttons.
4. Your code has been erased.
3. Learn the remote to receiver :
Press and hold both buttons until leds flash and the unit turns off.
You can learn up to eight transmitters. If you learn a ninth transmitter, the first transmitter will be deleted (first in – first out
principle).
SW3
SW1 SW2
LED