Velleman К8076 User Manual
Page 12
Advertising
12
19. PIC - selection cable
FIG 5.0
Software
FIG 4.0
Cut off a piece of each wire of the female 'board-to-wire' connector so there is 6cm of wire left on the connector.
See fig. 4.0
Cut off 5 pieces of shrinkable tube with a lenght equal to 1cm.
Slide the shrinkable tube over the wires of the female 'board to wire'-connector (fig. 5.0)
Solder each wire to a metal terminal
Attention: Always make sure to slide down the shrinking tube far enough from the soldering points!
Slide the shrinkable tube over the soldered joints and heat them using a hair dryer or, better still, using a paint
stripper.
6cm
Advertising