Velleman projects K5201 Assembly instructions - Manual (Page 12)

12

When mounting the kit in an enclosure you
should make sure the enclosure is sufficiently
insulated according to local norms.
 The complete PCB is best fixed to the front panel of
the casing, so that all controls are accessible and the
LED's are visible.
 Make holes in the front panel as shown in figure 3.0.
 Mount the PCB on the front panel with help of the
included bushes and bolts.
 Place buttons on the spindles of the potentiometer
(spindle diameter 5.9mm) and the rotary switch
(spindle diameter 6.3mm) (shorten the spindle if nec-
essary).
18. FINISHING
Finishing
All values are in mm. (1mm = 0.04")
FIG. 3.0