Velleman К8077 - Manual (Page 24)

24
(I) - Fix the speaker wires with some glue and trim them to a length of 20cm
- Slide an insulating sleeve over both wires. Solder a connector to both
wires and slide the insulating sleeves over the connector.
- Fix the 4 plastic feet by means of a 23mm screw and put the enclosure
on its feet.
(J) - put the heatsink in place and mark the 10 holes.
- remove the heatsink
- pre-drill the holes with a 1.5mm drill
- connect the red speaker wire to the connector marked 'LS+'
- connect the black speaker wire to the connector marked 'LS-'
- Carefully put the amplifier module in place.
- Fix the heatsink using ten 10mm black screws
Enclosure assembly