ZELMER 819 - Manual (Page 81)

81
− Be careful to put the cutting of filter partition
shall be fitted on proper insertion of the tank.
− Cover the back tank with the lid, as
show in the figure beside.
− Insert the hose edge into top lid inlet .
HOW TO START UP VACUUM CLEANER
− Take the plug and pull the cord out of the casing.
ATTENTION!!! Be careful during pulling the cord out, the yellow mark on the cord show the end
of the cord. Further trials (pulling) can lead to damage the cord.
− Insert the plug to the mains supply receptacle.
− Switch the vacuum cleaner on pressing the on/off button marked with
symbol
− You can adjust the desired suction power for 819.0 vacuum cleaner by
special buttons on the handle:
„
+
”increase power,
„ – ”reduce power
The currently set power level is indicated with one of four control
lamps. After each switching off, the power is reset as maximum,
despite the power set before
− When vacuuming with water filter unit, check the air
recirculation module knob position.
Place the knob in sucking position.
89B
OPERATIONAL INSTRUCTIONS FOR VACUUMING WITH WATER FILTER
− Avoid vacuuming surface covered with foaming enhancing substances. If we can notice through the
tank walls, that the water is very foamy, it is necessary to add anti-foaming agent recommended by
vacuum cleaner manufacturer, i.e. “FOAM-FREE” or “G 478 Entschäumer D”, in amount indicated
on the package. You can buy such agent in ZELMER S.A. network shops or by mail-order.
ATTENTION!!! Vacuuming with exceeding indicated, permitted level of water amount can result
in overflow out of the vacuum cleaner. Such repeated situation can lead to fast
blocking of final filter.
− You should pull carefully the vacuum cleaner across the doorsteps and other rough areas, not to
cause extensive water waving inside the tank. It can cause splitting small amount of water out.
− During long or very intensive vacuuming big amount of rubbish, water in the tank, which is the first
stage of filtration, can be completely or in majority absorbed by dry dirtiness. In such case replace it
with fresh and continue vacuuming.
ATTENTION!!! Long term vacuuming with very dirty water can result in early blocking of final
filter (HEPA filter for type 819,*.***S). It can also lead to vacuuming and filtration
efficiency decreasing.
− It is forbidden to pick up the materials and dirtiness, which can be dangerous for people and can
damage the internal elements of the vacuum cleaner, especially:
− flammable, corrosive, malodorous materials, chemicals, etc.
− high temperature materials and liquids,
− materials which are difficult to make damp such as: gypsum, cement, stone dust, flour, etc.
− too big and too sharp objects, which can be blocked inside the tube, hose or air ducts.
− In order to do use blowing, please set the air recirculation module knob in blowing position.
You can use this function for different purposes, especially for:
− blowing leafs out of balcony or patios,
− drying with warm air the inner walls of tubes and hose and other damp objects.
1
2
1
Vacuum cleaner
handle
Blowing Suction