Vitek VT-3542 SR - Manual (Page 9)

HOW TO STOP AN ALARM
Press [ALARM] on the unit to stop an alarm.
ALARM FEATURE
* Weekday Alarm
The alarm sound will be activated and the icon will be flashed on weekday when it is armed and
the alarm time is reach.
* Single Alarm
The alarm sound will be activated and the icon will be flashed once when it is armed and the
alarm time is reach. Once it finished, it will be disabled automatically.
* Pre Alarm
The pre alarm sound will be activated and the icon will be flashed if outdoor temperature under
or equal zero degree. Which is programmable 15, 30, 45, 60 or 90 minutes earlier than the
weekday alarm or single alarm time.
* The pre alarm can be armed only one of the weekday alarm or single alarm is armed.
*During the pre alarm mode, hold [ALARM] for two seconds the minute digits will blink press
[
#
] or [
$
] to change the settings.
Press [ALARM] to exit.
PRECAUTIONS
This product is engineered to give you years of satisfactory service if you handle it carefully.
Here are a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive materials. They may scratch the plastic parts
and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust, temperature or humidity, which may
result in malfunction, shorter electronic life span, damaged battery and distorted parts.
4. Do not tamper with the unit's internal components. Doing so will invalidate the warranty on
the unit and may cause unneces sary damage. The unit contains no user serviceable parts.
5. Only use fresh batteries as specified in the user's manual. Do not mix new and old batteries
as the old ones may leak.
6. Always read the user's manual thoroughly before operating the unit.
ENGLISH
9
3542.qxd 15.07.05 10:37 Page 9